Red Fox Technology Co., Ltd
Products Category
News

• Alternative Fixture Reduces PC • Conrad Launches Germany-Based • PCB Technology Interview With • Long duration timer circuit bo • Remote Control Circuit board d

Contact Us

Add: Longhua, Baoan Distric , Shenzhen, Guangdong, China
Name: Alice Chen
Tel: +86-755-83550636
Fax: +86-755-88350015
Mobile: +86-15919756296
E-mail: alice@gd-pcba.com
Skype: alice.pcba

Partners
google facebook
News

Remote Control Circuit board design Through RF Without Microcontroller

Author: Date:12/10/2014 12:12:23 AM
 
This is a simple type remote control board by using RF communication without microcontroller. In this project a remote has been designed for various home appliances like television, fan, lights and so on. It gives lot of comfort to the user since we can operate it by staying at one place. We can control any of the appliances by using this remote within the range of 400 foots. In this project consist of two sections, transmitter (remote) and receiver section. Whenever we are pressing any key in the remote it generates the corresponding RF signals, and these signals are received by the receiver unit. ASK transmitter and receiver is used as transmitter and receiver. HT12E, HT12D encoders and decoders are used in this electronic circuit board. 


Remote Section

In remote section consist of an encoder (HT 12E) and a ASK transmitter. The encoder generates 8 bit address and 4bit data. We can set the address by using the DIP switch connected in A0 to A7 (pin 1 to 8 ) encoder. If we set an address in the remote section, the same address will be required in the receiver section. So always set same address in transmitter and receiver. Whenever we press any key in the remote the encoder generates corresponding 4bit data and send this data with 8bit address by using ASK transmitter. The transmitting frequency is 433MHz. The transmitter output is up to 8mW at 433.92MHz with a range of approximately 400 foot (open area) outdoors.  Indoors, the range is approximately 200 foots.

Remote or Transmitter Circuit


Receiver Section

At the receiver section ASK receiver is present. The receiver also operates at 433.92MHz, and has a sensitivity of 3uV.  The ASK receiver operates from 4.5 to 5.5 volts-DC, and has both linear and digital outputs. It receives the datas from the transmitter. Then the decoder (HT 12D) decodes the date and it will enable the corresponding output pin (pin 10,11,12,13). Each output pins are connected to separate flip flops. The output of encoder will change the state of the flip flop. So its output goes to set (high) from reset (low) state. This change makes a high signal in the output of the flip flop. This output signal is not capable to drive a relay directly. So we are using current driver, SL100 transistor act as the current driver. The appliance is connected to 230V AC through the relay and the appliance will start. The relay will be re-energized when the same switch is pressed in the remote. This is because we are pressing the same switch in the remote control. The output of the decoder again goes to high so this signal will again change the state of the flip flop. So, the relay gets re-energized and the appliance goes to OFF state.


Remote Control Receiver Circuit board